User Instruction & Installation ManualFX560 Remote Control 2 Kilowatt Xenon SearchlightProduct Reference Number:A2471 – Variable Speed Motor Unit
Low capacity or an open capacitor affect ignition because there is insufficient surge current toreliably light the bulb. If disconnecting a capacitor
Back To Top
4 - Unpacking and Installation InstructionsThe following instructions should be read and fully understood prior to installing the equipment toensure t
5 - Electrical InstallationFor safety purposes, only competent personnel should perform the electrical installation. Allequipment should be installed
Installation GuidelinesA typical installation and connection routine for the searchlight with a Variable Speed Gearbox is asfollows:Referring to wirin
Fitting instructions for the 2Kw xenon lampReferring to the diagram overleaf:1) Unfasten the ten latches (A) on the front and rear of the searchlight
Back To Top
6 - Operating InstructionsThis equipment is designed for use out of doors, in free air. Never place anything on, or cover, thesearchlight when in use
Setting to WorkSafe service in use necessitates the strict observance of the following precautions. Any article fabricated from quartz or glass is i
Notes:1) XBO lamps are designed for dc operation only. The dc current may only be varied within thelimits of the current control range. An XBO lamp
CONTENTS1 - Introduction2 - Safety Precautions3 - Technical Information4 - Unpacking and Installation Instructions5 - Electrical Installation6 -
7- Fault FindingAll fault finding must be conducted by a competent person or qualified Electrical Engineer.Please refer to the following table for th
Failure of Lamp to IgniteIn the event of the xenon lamp failing to light the following steps should be taken:1) Check that the mains supply is conne
8 - Maintenance and ServicingIn order to prolong the service life and performance of your searchlight, the following maintenanceguidelines are recomme
9 – General Assembly & Wiring DiagramsDrawing Number DescriptionA2471/A2473 FX560RC 2Kw variable speed G.A.C22801 2Kw Xenon RC Wiring Diagram vari
Back To Top
1 - IntroductionIt is imperative that this manual is read carefully and understood beforeinstalling your equipment. For your future reference please k
10 - Spare Parts ListThe following spare parts can be ordered directly from the manufacturer:Part Number DescriptionC15392-00 Power Supply Unit (240v)
2 - Safety PrecautionsThe following instructions must be adhered to, in order to ensure a safe working environment andthe safety of the user.Note: Whe
3 - Technical InformationThis product has been designed to operate in accordance with the product specification. TheFX560RC 2000 watt searchlight has
Power Supply Details (Model 8502)General DescriptionOutput Power 1400-2200 wattsVoltage 22-30 volts D.C.Current 50-85 amperes D.C.Ripple 5% peak-to-pe
CautionDo not allow anything to be placed upon the power supply case; the perforated top is forventilation and must not be obstructed.Try to select a
WarningThe power supplies have two sources of power. Disconnect (turn off) primary power beforemaking adjustments or service procedures.Output power a
Xenon lamp power supplies have two stages of operation:1) Before igniting the bulb – At this time, the voltage at the power supply output terminalsre
Comments to this Manuals